This was posted 5 years 10 days ago, and might be an out-dated deal.

Related
  • expired

12V- 5V Hard Wire Kit with Mini USB Power Cord for Dash Cameras $9.98 Delivered @ SydneyCarSecurity eBay

30
12V- 5V Hard Wire Kit with Mini USB Power Cord for Dash Cameras $9.98 Delivered @ SydneyCarSecurity eBay
Go to Deal
Cashback
Associatedfelow @ Strathfield Car Radios on 12/11/2019 - 10:02 ebay.com.au (283 clicks)

Hardwire your Dash cam to your battery
Make full use of your camera’s parking mode by getting permanent power from your car battery.
No need for cable from car cigarette lighter socket, replace it with a permanent hidden cable
Support continuous video recording when the vehicle is parked
Standard Mini USB adapter to connect to your dash cam
Easy to install, fast plug & play
You can install in minutes and does not require electrical expertise.
Compatible with 12-24V DC cars, vans and trucks
Avoid your battery from being drained by dash cam
When the car power supply voltage drops to 11.6V it automatically turn off the camera
Note: If you don't have any electrical background please contact a professional to avoid unwanted circumstances.

Automotive

Related Stores

eBay Australia
eBay Australia
Marketplace
Strathfield Car Radios
Strathfield Car Radios

closed Comments

  • Waynes world on 12/11/2019 - 10:20
    +1

    This type of device has been around for a while. I've installed similar in my vehicles, using a separate USB cable, allowing me to choose the connector type. Although I haven't seen one with low voltage cutoff till now. Great idea. However, nowhere in the listing can I find how long the cables in and out are. This can be important.

    • AssBargain on 12/11/2019 - 11:33
      +1

      Messaged them:

      Input line length is 95cm, box length is 5cm and output line length is 220cm

  • WesthamAreMassive on 12/11/2019 - 10:45

    What's the best voltage to go down to so car will start and not damage battery with these?

    • edrift on 12/11/2019 - 13:10

      After doing some reading 11.6v sounds way too low to maintain a healthy battery.
      Your car may start at that level, but you'd want to make sure you don't let it drain to that level too often.

      If you have a new/healthy battery, my guess is you could run the dash cam on this kit without damaging the battery as long as you drive the car daily so it can recharge, or run it on a trickle charger.

      People suggest a healthy voltage is at least 12-12.2v

  • SnoozeAndLose on 12/11/2019 - 10:51

    This one doesn't have seperate fuse insert so I would avoid, also missing connector for the wire to connect to ground.

  • cristtos on 12/11/2019 - 13:02
    +3

    "Compatible with 12-24V DC cars, vans and trucks
    Avoid your battery from being drained by dash cam
    When the car power supply voltage drops to 11.6V it automatically turn off the camera"
    You are in deep trouble if your 24V supply drops below 11.6V…

  • boonhowe on 13/11/2019 - 01:53

    Is it possible to use a 10000mah battery pack with passthrough charging between the dashcam and the lighter socket?
    dashcam <—- battery pack <—- USB charger on light socket

    So if car engine is on, power passthrough battery pack to run the dashcam.
    engine off, uses battery pack until power is drained.

    car battery is safe from over discharge

    • edrift on 13/11/2019 - 08:00

      Yes, but not all power banks can be used and charged at the same time (good quality ones can).

      You could even get a solar one and have that charge in the sun whilst the car is off.

Login or Join to leave a comment
Login Join