SevenSmurfs » user profile

Member Since 10/09/2012
Last Seen 1 hour 25 min
Badges 3 4
Location Melbourne
Website ozstraps.com.au

Recent Activities

Anyone gone to Exetel from Superloop? Tempting to put in my 30 days cancellation now
30/06/2025 - 23:25
Not sure how you're getting $288.92, my checkout is saying $300.95
30/06/2025 - 23:14
Thanks for this - I'm in the same position with the inverter / panels Are these prices considered a good deal?
30/06/2025 - 11:04
Any reason not to get this one instead - 20L with wifi…
26/06/2025 - 11:40
Any reason not to buy this version over the ps5 one if it gets the free upgrade?
22/06/2025 - 20:00
Only legit way that is cheap at the moment is Buy from Costco…
30/05/2025 - 10:32
Agreed - have had one since launch and unfortunately without the 12w solar panel, the entire feature set is pretty useless and cannot be a…
12/05/2025 - 14:21
That seems cheap - does it include gateway? Can you PM the contact
09/05/2025 - 15:53
thanks am on 4K OLED with a RTX3080 so am trying to decide whether it will run better on PS5
07/05/2025 - 10:37
Is this not the better buy with 2 probes so you can check ambient temp as well? https://amzn.asia/d/60HiSJn
06/05/2025 - 14:03
how do you get the 10% gift cards from Coles?
01/05/2025 - 10:39
So better buy on ps5/portal than pc/steam deck?
27/04/2025 - 20:47
Will ghosts survive with a dwarf gourami?
23/04/2025 - 21:21
how necessary is it to replace? Can you simply take it outside and blast it with a garden blower and have it back to nearly the same…
12/04/2025 - 20:47
Any idea how long the Z6000 & Z7000 models filters will last? Most likely to become landfill once the filters are done, unless can give…
08/04/2025 - 10:14
Where do you find the Sunlu PETG settings in Orcaslicer-Flashforge
04/04/2025 - 15:32
Mine failed in that it would switch on and off randomly
01/04/2025 - 20:55
Do you increase the temps in orcaslicer / flashprint or directly on the flashforge
20/03/2025 - 11:28
Have been happily printing PLA. Is it better to switch over to PETG?
14/03/2025 - 12:06
The free filament got jammed, ended up cutting it and pushing it out and putting my filament in!
13/03/2025 - 15:26
Received mine today, did two prints and then onto the third, no filament coming out for some reason. Already onto troubleshooting and…
12/03/2025 - 19:49
Loading...