Ok, so one of my roller blind had its chain came off its track, so I googled and did the first thing i saw, which was to pop the ends of. Well big mistake which i didnt realise until later. I managed to put the chain back in and when I tried to put the blind back to its bracket, i noticed the other end (with no chain) couldnt hold up. And noticed at the bottom floor were some broken plastic parts. I don't know what parts I need to replace so please help
Here is what the broken end look like now vs what it should be:
http://imgur.com/a/Ejpx2TS
If you know a video how to replace it too, that would be great
Thanks ozbargainers
Edit: i unscrewed fhe bracket and i believed i just need a plier to pull the other end out a little for it to hold itself in the slot of the bracket? At the moment its quite deep inside and only a little poke out
Need Replacement Parts for a Roller Blind
gustus on 21/10/2020 - 20:48
Last edited 21/10/2020 - 21:01
Last edited 21/10/2020 - 21:01
Comments
Depending on the size of the tube through the middle of the blind, you may be able to fix it with this:
https://www.bunnings.com.au/windoware-25mm-round-tube-roller…But you would have to reinstall the brackets.
Did you try blindpartsonlineaustralia.com.au Or blindpartsaus.com.au/blind-parts-shop/
It looks like part of the lower slot is broken, allowing the roller/ end pin to fall through the slot. I would drill a small hole in the slot and screw in a short thick self tapper or a small nut & bolt to fill the lower channel, and provide a support for the roller pin to function. Just make sure the drilled hole is the right size for the fixing size or you might split the plastic end support. Good luck.